Points for attention in daily use of light-touch switch
 2019-12-29 9:26:17       乐清市金鼎电子科技有限公司

What problems are easy to ignore when using the light-touch switch? This article will introduce in detail what we need to pay attention to when using the light-touch switch, details are as follows: Use of light-touch Switch Note 1, on the welding conditions set, please according to the actual conditions of mass production. The use of light-touch switch note 2, because welding, water-soluble flux has the possibility of corrosion switch, please avoid using. The Use of light touch switch note three, if the rated voltage in excess of use, there will be the possibility of poor contact, for the above-mentioned circumstances, please confirm. Please note that the circuit setting software should be set into a combination component according to the pulsation and Oscillation of each switch type without misoperation. Five, the use of light-touch switch points five, carbon contact with the load due to the push-pressure contact resistance changes in the characteristics. For Voltage Divider Circuit, please use after full confirmation. Use of light-touch switch note six, the product to DC resistance load as the premise of the design and manufacture. When using other load induction load L, capacitance load C, please confirm separately. Seven, the use of light-touch switch can not be cleaned. For the flat shaft type, try to press the switch center. For the hinge structure, press down when the axis bar moving position will move, please pay special attention. Use of light-touch switch note eight, if the use of the whole machine around the material produced corrosive gas, will be likely to cause poor contact and so on, so please fully confirm in advance. When welding the terminal, if a load is applied on the terminal, it will become loose due to different conditions, and the possibility of deformation and electrical characteristics deterioration, please pay attention when using. Ten, note that the use of light touch switch, note that the upper limit of the temperature range can not be used near the lower limit of long-term continuous use. Please note that all environmental tests shall be carried out within the product specifications specified in the conditions of use. Oh, Shit